question about pos battery relocation fix - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

sliEighty · 09-30-2008, 11:02 PM

I have relocated my battery to the trunk and have everything run up to the engine compartment. I was wondering what people did with the positive wire going to starter ect... Just connect them and tape the hell out of it came to mind but i want it done right and neat.

chris

Deftec · 09-30-2008, 11:12 PM

I ran mine to the starter, then up to a junction block that I mounted on the fender well. Spliced the two white/red stripe wires together and put a connector on it. Connected it to the junction block.

sliEighty · 09-30-2008, 11:17 PM

Where did you get your junction box at, and what amp is it for?

something like this? http://www.hotrodwires.com/cart/tek9...cific=jnrpqpo0

09-30-2008, 11:02 PM	#1
sliEighty Zilvia Junkie Join Date: Jan 2006 Location: Central pensyltucky Posts: 471 Trader Rating: (3) Feedback Score: 3 reviews	question about pos battery relocation fix I have relocated my battery to the trunk and have everything run up to the engine compartment. I was wondering what people did with the positive wire going to starter ect... Just connect them and tape the hell out of it came to mind but i want it done right and neat. chris __________________ livin on the east cost is harder then you think... ECM for life lll

09-30-2008, 11:17 PM	#3
sliEighty Zilvia Junkie Join Date: Jan 2006 Location: Central pensyltucky Posts: 471 Trader Rating: (3) Feedback Score: 3 reviews	Where did you get your junction box at, and what amp is it for? something like this? http://www.hotrodwires.com/cart/tek9...cific=jnrpqpo0 __________________ livin on the east cost is harder then you think... ECM for life lll

09-30-2008, 11:12 PM	#2
Deftec Zilvia Junkie Join Date: Apr 2007 Location: ks Posts: 376 Trader Rating: (0) Feedback Score: 0 reviews	I ran mine to the starter, then up to a junction block that I mounted on the fender well. Spliced the two white/red stripe wires together and put a connector on it. Connected it to the junction block.