Innovate MTX-L question/issue - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

R3cK · 07-05-2013, 06:13 AM

Wired and calibrated my MTX-L
worked fine while not driving and playing with the throttle.
then i drove only some feet and suddenly it shows the E2 code again

E2 means no sensor detected like when you have to calibrate it.
any ideas?

i read about people got the same issue and even replaced the sensor but had the same problem after that.
no solution so far..

tobroketobuildarealcar · 07-06-2013, 12:57 PM

Make shure you have a good ground for the electrical circut

I have seen so many odball problems happen bc of a bad ground

07-05-2013, 06:13 AM	#1
R3cK Zilvia Member Join Date: Nov 2011 Location: bavaria Posts: 159 Trader Rating: (0) Feedback Score: 0 reviews	Innovate MTX-L question/issue Wired and calibrated my MTX-L worked fine while not driving and playing with the throttle. then i drove only some feet and suddenly it shows the E2 code again E2 means no sensor detected like when you have to calibrate it. any ideas? i read about people got the same issue and even replaced the sensor but had the same problem after that. no solution so far..

07-06-2013, 12:57 PM	#2
tobroketobuildarealcar Zilvia Junkie Join Date: Feb 2013 Location: Florida Posts: 508 Trader Rating: (0) Feedback Score: 0 reviews	Make shure you have a good ground for the electrical circut I have seen so many odball problems happen bc of a bad ground