Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > S Chassis

S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15.


Reply
 
Thread Tools Display Modes
Old 06-27-2012, 11:41 PM   #1
slideways SR20
 
slideways SR20's Avatar
 
Join Date: Jun 2012
Location: Wilmington, NC
Age: 29
Posts: 11
Trader Rating: (0)
slideways SR20 is an unknown quantity at this point
Feedback Score: 0 reviews
Unhappy Chasing idle problems.....

after completing my s13 sr20 swap it ran good for a few days, maybe a week but then i discovered it had a blown turbo gasket, as well as it was starting to run rich and idle like s**t. i replaced the gasket and the car was still running rich. i had a walboro 255 and the stock fpr. so i upgraded to areomotive afpr setup and tuned it to 43.5 psi w/o vacuum source. when i stated it ran perfect and i allowed it to idle while i checked again for leaks. after a couple minutes idling it begins to miss slightly. fuel pressure is good but rpms begin to bog down a little. this is about the same as it was doing before the afpr minus the smell of gas... so i'm thinking it could be a bad coil, ignitor chip, or something with the maf? any thoughts are appreciated... tired of spending money. also if its any help befrore the aero fpr, when it was running rich, it didnt seem to boost.. thanks again
slideways SR20 is offline   Reply With Quote
Sponsored Links
Old 06-28-2012, 12:54 PM   #2
slideways SR20
 
slideways SR20's Avatar
 
Join Date: Jun 2012
Location: Wilmington, NC
Age: 29
Posts: 11
Trader Rating: (0)
slideways SR20 is an unknown quantity at this point
Feedback Score: 0 reviews
no thoughts?
slideways SR20 is offline   Reply With Quote
Old 06-29-2012, 07:06 PM   #3
godsmack
Zilvia Addict
 
godsmack's Avatar
 
Join Date: Feb 2009
Location: Allentown, PA
Age: 38
Posts: 652
Trader Rating: (0)
godsmack is an unknown quantity at this point
Feedback Score: 0 reviews
pull the plugs and check for 1 of the plugs to be soaked after you start it up. i bet you have a leaky injector.
godsmack is offline   Reply With Quote
Old 06-29-2012, 07:07 PM   #4
godsmack
Zilvia Addict
 
godsmack's Avatar
 
Join Date: Feb 2009
Location: Allentown, PA
Age: 38
Posts: 652
Trader Rating: (0)
godsmack is an unknown quantity at this point
Feedback Score: 0 reviews
oops nevermind. if it would boost fine then i would lean towards the leaky injector. check your temp. sensor and for vacuum leaks.
godsmack is offline   Reply With Quote
Old 06-29-2012, 07:16 PM   #5
ultimateirving
Zilvia FREAK!
 
ultimateirving's Avatar
 
Join Date: Nov 2010
Location: arizona
Age: 36
Posts: 1,521
Trader Rating: (1)
ultimateirving is an unknown quantity at this point
Feedback Score: 1 reviews
Being that this is a brand new swap, I would highly advise Pressure testing your system. Build a boost leak tester, and you can find all those vacuum lines and couplers that you didnt quite tighten enough.
__________________
Z32 with lq4 swap
Desert Street Scene || Dssevents.com
ultimateirving is offline   Reply With Quote
Old 06-29-2012, 10:28 PM   #6
slideways SR20
 
slideways SR20's Avatar
 
Join Date: Jun 2012
Location: Wilmington, NC
Age: 29
Posts: 11
Trader Rating: (0)
slideways SR20 is an unknown quantity at this point
Feedback Score: 0 reviews
i appreciate the advice i will defintily check for boost or vacuum leaks as well as temp sensor. i drove it today and its strange it drove fine, although felt like it wasnt boosting, and revs would did really low under decel, but then while turning into advance it just shut off. got maf cleaner, cleaned it and it started up and died right away. then started up and idled fine but was missing or stuttering. so im thinking possibly AICV or coilpack/ ignitior chip.
slideways SR20 is offline   Reply With Quote
Reply

Bookmarks

Tags
fpr, ignition coil, maf, rich, sr20



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:48 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net