Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > Marketplace > For Sale Items > Cars For Sale


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-08-2016, 09:22 PM   #1
culaphid
Zilvia Junkie
 
Join Date: Nov 2012
Location: tehachapi
Age: 30
Posts: 547
Trader Rating: (0)
culaphid is an unknown quantity at this point
Feedback Score: 0 reviews
2003 Lexus Is300... Ls-Turbo/t56 Manual

I am putting this up for sale because I am buying a house and since me and my wife have 4 other toy-like vehicles it's time to narrow it down. This car runs and drives excellent like it would if it were built this way from the factory. This thing breaks necks like nobody's business, as you could imagine. Before I go any further, the chassis holds a SALVAGED title. It was involved in a minor front end accident in a parking lot, the front bumper was damaged. It has since been tubed in the front, and it has absolutely no residual damage from an accident. I have the title in hand and current California tags as well. On to the spec list, I'm sure I will forget a lot.


Please excuse the order, I write them as they come to me:

Beautiful pearl white paint, some minor rock chips in the front bumper, and a few on the passenger front fender. Nothing crazy at all.
Clean body
130k chassis miles
All working Windows and door locks
Working door locks and trunk from master key
Decent interior compared to most of them out there, the interior is tan and black, typical dash scratches (not cracks) and a small hairline "rip" in the back of the passenger seat (hardly notice) and some minor non-puncturing cracks in the side of the drivers seat.
No stereo at the moment, all wired up for a nice system.
Rear mounted battery
Brand new Niche wheels (18x8/18x9.5) with good tires (225/40 front 265/35 rear)
Altezza grille
Tinted rear Windows
False headlight/turbo intake where high beam was
Large 6 piston front calipers
D2 coilovers
Supra clutch type lsd and 3rd member
Custom intercooler settup
Knock off tial blow off valve
Real tial Wastegate w/external dump tube
Large aluminum radiator
EBay universal manifolds, drivers cut and welded slightly for length
Custom manifold connector
Custom downpipe to a beautiful fully custom single to dual exhaust with plenty of muffling power, very quiet until under boost.
Tubular front end reinforced 6" into the frame
Notched and reinforced sub frame
Lots of reinforcement underneath for extra strength for the obviously high torque output.
Beautiful driveshaft, balanced
Custom wiring harness
Custom coil pack harnesses
Working factory speedometer and tach
Obd2 port in factory location with working check engine light
Boost guage, wideband, and Mini cluster (plugs into obdii port, displays all kinds off stuff, currently set on iat, water temp, rpm [pointless] and voltage) all in a carbon fiber panel located in the factory nav area which still flips up and down, looks very cool
Mr2 electric power steering pump with aluminum reservoir mounted on the valve cover
2004 gto t56 transmission with low miles, Hurst shifter, and no issues whatsoever. Very solid.
2004 ls1 gto accessories (oil pan, front drive assembly, intake manifold, throttle body, etc.)
2003 Silverado iron block 5.3L Ls based engine with under 100k miles
Ls2 flywheel with New ls7 clutch
Msd diy super conductor plug wires
Speed density tune with a gm 3 bar map sensor
78mm offbrand turbo
Custom aircraft grade turbo oil feed line
Hallman pro manual boost controller set to 10-12 psi depending on elevation, very reliable and stable boost controller
I'm sure there's so much more I'm forgetting.



Cons:
Hood sticks up just barely because of the intercooler piping, I'm sure it could be corrected
Coil packs could be mounted slightly better
No heat or a.c. at the moment. HOWEVER, all you need for heater is lines, I had them working at one time, and I have a custom condenser and line settup for an ls1 is300 that will be included so that you can have Working a.c. and make this you're ultimate daily driven race car.
I don't have dyno numbers for this car, however with valve springs and a cam, I have made over 700 whp with a settup the same as this. I have an lq9 6.0 for it but I am keeping it for another car. For those who don't know about ls motors, they are very interchangeable, with no modifications. If you are unhappy with the longblock installed in here, I will swap it out with any longblock of your desire (ls1, ls2, ls3, lq4, lq9, etc.) for a fee. No discounts.
Random misfires every now and then at idle, that's what you get for running a speed density tune.
EBay turbo burns some oil at random times


This car is so much fun to drive. The turbo screams and sounds awesome. Drives just as smooth at 20mph as it does at 100. I am fine with out of state buyers, but serious buyers only please. With that being said I am asking $12,000 obo, no dumb offers please. Please keep the negativity to a minimum (none preferred)

661-858-7027


I will try and get more pictures up tomorrow. Tired hands from typing the car is obviously dirty in the pictures.


Last edited by culaphid; 08-26-2016 at 11:08 AM..
culaphid is offline   Reply With Quote
Sponsored Links
 

Bookmarks



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 06:01 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net