CA FS/FT: 1998 S14 Kouki **Fully Built RB25**

[EvolutionVIII]

Up for sale is my monster 1998 RB25 S14. I hate to sell this car but I am daily driving it and I don't want to get a ref ticket so its gotta go! When I got this car a couple months ago, it had a blown motor with damage to all six cylinders from running too much boost on stock internals. Since then, the engine was rebuilt and built by SR20Store about 2500 miles ago. It was also retuned by Rotary Reliability and Racing after the build about 3 months ago. I have receipts for both the tune and the build! It now runs absolutely perfectly and is pushing 414 to the rear wheels on 14 PSI and 91 octane. The interior is absolutely perfect 10/10 with leather back seats and no rips, tears, or scratches anywhere! The exterior is 8.5/10 as there are a few cracks here and there but nothing too bad. It's still extremely clean! The swap was done almost perfectly and looks like it comes stock like that. Everything was done really clean and a lot of time and money was put into this car. I am looking to sell or trade it. Price is 15,500 OBO. I can also keep the wheels and seats to lower the price a little. Im in absolutely no hurry to sell so you can leave your lowballs at the door! As for trades, I'm looking to get into something like an Evo or an STi. This car is a great, really fun car that with the build, can be running 600 hp with race gas and meth. It is tuned at 414 hp to the rear wheels on a safe reliable tune! Heres the list of mods!

BODY/Chasis
- Clean Title 1998 Nissan 240sx LE Kouki w/ ~230ishKM on body(138k miles)
- S14 rare cream beige leather back seats
- Powered sunroof
- No surface body rust and cleanly maintained
- Spare tire removed
- Windsheild washer fluid removed
- AC system removed

ENGINE
- Series one Rb25DET with about 2500 miles on it. Just fully built by SR20Store
- GM 3-bar map sensor
- GM IAT sensor
- NEW rb25det coilpacks
- 750cc RC injectors
- 255lph Walbro fuel pump
- Custom highflow Fuel rail
- Earls Fuel gauge
- AEM DryFlow conical intake
- Dual 12inch flexilite pusher fans with a bypass switch in the cabin.( you can either let the thermostat turn it on or do it yourself!!)
- Z32 fuel filter
- Koyo radiator
- Greddy style intake manifold
- Q45 throttle body
- New rb25det oilpan and gasket
- Firesleeved vac hoses and brake lines near turbo
- Re-hosed all water lines under intake manifold
- ARP Head Studs
- Greddy Metal Head gasket
- Externally Dump waste gate
- MCkinny lifetime warrent rb25det into s14 conversion motor and transmission mounts
- Mckinny Drive shaft with life time warranty
- CP Pistons (87 mm)
-N1 Water Pump
-N1 Oil Pump
-New Timing Kit
-New Seals
-New ACL Bearings
-Nismo Thermostat
- BINGS HUGE FMIC
- INTENSE MOTOR SPORTS 3INCH Intercoooler piping
- Custom steel bracket
- All piping tig-welded by your one and only Intense Motor Sports and Rstuning

ELECTRONICS
- AEM EMS
- Prosport Halo series, oil pressure + temp, water temp, and boost gauges
- AEM Wideband installed but reads incorrectly
- Battery relocated to the trunk
- 0/1 Gauge positive battery cable directly hooked up to starter from battery
- 0/1 Gauge negative battery cable directly hooked up to front block from battery
- Engine harness fully reassembled, re-pinned, and neatly soldered, heatshrinked and taped by RSTUNING

TURBO SETUP
- Forced Performance HTA GT3076R with .82 A/R ball bearing turbo
- Tial 44mm external dumped wastegate
- Turbosx RFL blow off very very loud
- AEM boost controller solenoid
- Earl AN lines were used
- Tubular XS exhaust manifold
- AEM dry air filter

SUSPENSION/DRIVETERAIN
- ACT Heavy-duty pressure plate w/ single plate clutch
- Tiens flex coilovers
- Megan front and rear sway bars with megan endlinks
- Micknny ENGINE mount
- Mckinny Transmission mount
- Mckinny Driveshaft
- Cusco front+rear strutbars
- NEW front and rear wheel studs

EXHAUST
- OEM rb25det exhaust gasket
- INTENSE MOTOR SPORTS 3inch Downpipe
- RSTUNING 3inch Catless cat
- AEM o2 sensor
- INTENSE MOTOR SPORTS INSTALLED APEXI EXHAUST
INTERCOOLER

BRAKES
- Z32 iron 30mm calipers, front
- Russell brake lines, front
- Brembro blanks in the front
- Carbon kavelear pads Front and Rear

Wheelies
- 18x9.5 5Zigen ZR+ 520
- Potenza RE760 Sport tires(255/40R18 front: 275/35R18 Rear)


INTERIOR
- 2 Bride Lowmax Seats with 5 point Harnesses
- Momo shift boot
- Megan cpillar bar
- NRG quick release
- NRG hub
- MOMO Deep dish wheel

EXTERIOR
- AIT R33 front bumper
- Battle series carbon fiber vented hood
- AIT R33 style side skirts molded into the body(it looks like its one full body panel from the front fender to the back fender)
- Custom molded fender flares
- Version select V4 rear bumper.
- LED taillights + centersection
- Roof is vinyl wrapped flat black.
- 35% tint all around

As i said Im looking to trade for an evo or sti but I may be interested in other things as well. Price is 15,500 OBO. This car has A LOT of time and money put into it. contact me for more pictures! IF youre interested, shoot me a text at 818-274-6881 or a PM. Thanks!