s13 wire tuck+fuse & relay boxes re-location

[Gorilla Unit 33]

Originally Posted by WakeBHR

hey gorilla unit where did you get your fender tubs?

J-Tuned Motorsports
Mike Fagan - Fabricator
484-614-8595 ask for Jim tell him LJ sent you.

Originally Posted by Om1kron

no, a swirl pot needs to be higher than the highest water level the coolant reserve does not need to be as it is insufficient in removing air pockets from the cooling system.

ok that make sense, i just wasnt too sure about the ps resi. I know that shit can be tricky sometimes.


On to other news, i was shooting to have my car finished and running by next weekend to be at the D1 event @ englishtown but i slipped up today working and almost cut my finger off. I should have stiches but i dont have insurance so im fucked. Anyway i cant solder or really do most of the work it would take to get my car done with one hand, so unless i find some really helpful dependable friends over night or some really good meds that will keep me coherant enough to do this shit its not hapening.