PDA

View Full Version : Need Help Please Help Sr Wont Start


sicairos_2007
06-09-2008, 08:28 PM
Ok i swapped in my sr from another 240 it ran and now that i put it into this hatch back it wont start at all, i already Checked for spark, compression, and fuel, so im really out of ideas now any ideas will be apriciated, also when im cranking the engine it make a pop pop noise once in a while i been messing around with the CAS iv been following the frsport manual and no good so please I need some help been working on it for days now

Sil-Eighty SE-K
06-09-2008, 08:37 PM
check the coolant temp sensor to the ecu (big one) is it plugged in?

if so prolly timing

sicairos_2007
06-09-2008, 08:41 PM
i feel dumb but is that the under the intake manifold? thanks alot for the reply

Sileighty_85
06-09-2008, 08:52 PM
i feel dumb but is that the under the intake manifold? thanks alot for the reply

No its right above the Thermostat housing you will see two sensors next to each other its going to be the Left one (A 2 lead sensor with a square plug)

See the red plug toward the frot right next to the timing chain tensioner?
Thats the one.

http://i73.photobucket.com/albums/i235/Neil_85/IMG_0862.jpg

Check you ECU for codes also, it will save a lot of trouble shootin. CTS will be Code 13

sicairos_2007
06-09-2008, 09:08 PM
Just got back from checking that and it didnt work, just makes the same back fire noise once in a while, iv been messing with the cas timing and wouldent it atleast start if it was close and i know im atleast alittle close.

sicairos_2007
06-09-2008, 09:10 PM
Will Check for codes right now never done it before but iv read a few forums on it

Sileighty_85
06-09-2008, 09:14 PM
well if it were the CTS you would have to replace it in order or it to fix it

Normally when the CTS is bad your engine will run rich and take 15 seconds of cranking to turn on after the engine is warm, but will start when cold

sicairos_2007
06-09-2008, 09:21 PM
na im pretty sure its not that just because it dosent start at all...... thanks for the replies man

sicairos_2007
06-09-2008, 09:40 PM
my ecu is shooting a code 55

sicairos_2007
06-11-2008, 09:34 AM
hey thanks for the help everyone I got it to stat now the timing was way off now I guess now I just need to adjust that now because it back fires alot