|
Engine Tech Technical discussion related to all relevant engines such as KA, SR, RB, CA, 2JZ , L24/26/28, VG, VQ, and LSx series. |
|
Thread Tools | Display Modes |
07-19-2008, 11:00 PM | #1 |
Zilvia Junkie
Join Date: Aug 2006
Location: omaha, ne
Age: 34
Posts: 451
Trader Rating: (2)
Feedback Score: 2 reviews
|
ka24e rough idle, sometimes smooth!? searched
i put a low mile ka24e in my 1990 and it idles rough, around 650 rpm. i have changed plugs(gapped), wires, dist cap, heag gasket, Timing chain is double checked, dead on 15 degrees, new intake gasket, exhaust gasket, and throttle body. cleaned iacv. today i changed my injector o rings because one was a bit chewed up. also a new o2 sensor.
funny thing is that it will rarely start up and have an fantastic 800rpm idle , hot or cold, and then go to crap and idle roughly a few minutes later. it does not hesitate when i rev it to take off, and eveything about 1,000rpm and above is fine and smooth. all vacuum lines were checked today as i also tried a new wire harness. everything hooked up and started with a rough idle yet again. any other possible solutions? i havent been stumped like this before haha. please give suggestions thanks a bunch. -jason |
Sponsored Links |
Bookmarks |
|
|