TX AE86 GTS hatch Kouki Levin ( Near Houston) 5K OBO

[kashira kureijii]

I have a 1985 GTS I'd like to get sold. My main reason for selling is that I don't really have time for it, but me never being able to fit inside of it is another large reason. I'm to tall for this car, and it really was an impulse fanboy purchase. If you are Less than 6'3 and want a good ae86 project this is the car for you

1985 Corolla gts
AE88 vin, so original GTS, Clean title
Cluster reads 167k, but car has been swapped so I don't know if it's original or not

Cusco LSD
15'' Koenig watanabe knockoffs w/good falken rubber
slotted rotors
stainless lines
upgraded tension rod in rear
Walboro fuel pump
MOMO steering wheel with quick release
Knockoff taiwan recaro's
Autopower rollcage
Most parts were installed by PO in the early 2000's
Has early 2000's "gymcana" adjustable dampeners, one of which is blown.
Kouki Levin front, with front Lip
Kouki redline tails
Apexi rev meter (old, not installed currently cuz new harness)
Apexi SAFC (old, have not installed cuz new harness)
New megan racing engine mounts still in box
Brand new mishimoto rad w/electric fans
unknown header
Greddy DD exhaust
Replacement GTS underdash/bay harness, I've rewired it up for levin lights
*includes Old faulty harness with fuseboxes etc

Comes with a running Last Gen 4AGZE that i removed cuz it had a tore up wiring harness. I have extra coilpacks for it, and had installed new denso sparkplugs before I figured out it had faulty wiring. I also have the full starion intercooler setup with HKS shroom filter that it was running

Also comes with T50 trans w/Techno toy short shifter and another W-series trans (i think from a pickup?) with a nitekids? custom bellhousing. I also have an new exedy MR2 GZE clutch setup w/throughout bearing, but I dunno if it will work on a rwd setup[edit: it will work, provided with the ancillaries, some of which I have included(clutch fork, pilot, etc. I have a pickup throwout bearing, but have not tested its fitment) http://convertmotorsport.co.nz/conversion-parts/]

I had to fix the underdash harness because the car was bought with a toasted harness. I sourced another GTS underdash( which was a pretty hard source, and took a while cuz demand) and engine bay harness (w/4age engine harness) and have installed it, so the dash is out. I have all the interior and it is in average condition. the dash is slightly cracked but I have a dash mat for it. the rest of the interior parts seem fine.


















Car is a shell so you will need to bring a trailer.

Serious offers only please, I am in professional school, so I really don't have much spare time to show the car etc.

Car is located in College Station, TX, Which is about an hour out of houston

$5,000 OBO. may trade for a running stick shift daily driver car of similar value
I paid 5k for it when I bought it, and have done stuff to it since then