PBM subframe riser install

[terrence]

Originally Posted by Tempo

You're about a half inch lower than me looking at that pic. Hmmm

Sent from my HTC Sensation 4G

I got/had the same problem as you. Right now I'm swapping the sub-frames between shells but I took a sawzall to that edge till it was flush. The ruca would still hit the frame (megan ruca), but I was pretty low. I think on this new shell I am going to grind it down and notch the frame for more clearance since I plan on being a little lower this time.

My biggest issue was the brake cables, they would always rub my drive shaft. I had to bang out a dent to clamp them into, I'd like to do something different this time but not sure yet.


Here is how the old car sat for reference:

[Nostalgic Hiro]

Originally Posted by terrence

I got/had the same problem as you. Right now I'm swapping the sub-frames between shells but I took a sawzall to that edge till it was flush. The ruca would still hit the frame (megan ruca), but I was pretty low. I think on this new shell I am going to grind it down and notch the frame for more clearance since I plan on being a little lower this time.

My biggest issue was the brake cables, they would always rub my drive shaft. I had to bang out a dent to clamp them into, I'd like to do something different this time but not sure yet.


Here is how the old car sat for reference:

Dude, saw the video!!! Sorry about the loss. Your car is awesome. What caused the fire though. Your S14 is inspiring my S-chassis build