IL FS: 2002 Toyota MR2 Spyder/MR-S - 2ZZGE, 6spd, Kaaz LSD, HKS coils, TE37 - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Nachtmensch · 08-19-2012, 11:37 PM

Obviously I have a whole lot of time and money into this car. I have owned it for 4.5 years, since the chassis had 51k on it. The chassis now has 105k. The 2ZZ motor has just over 14k on it now and the car is my daily driver and has been garaged the past 3 winters avoiding any salt. The body panels need some love because the car has seen lots of track time. I warm the coolant and oil up before revving high (9000 RPM redline). The car runs on 93 octane and made 207 whp at ILL Garage. Not bad for a 1.8L in a 2250lb car

Honestly, this is the most fun I have had in a car (over any other car I've driven) and it will be sad to see it go. Driving it pins a smile on me and has given me no problems.

Location: DeKalb, IL
Price: $18,000 as is, pricing can change by not including TE's, suspension, or engine/trans. I have well over that into this car.
Email: [email protected]

Engine/fuel/management
Low mile 2zzge block (60k)
Monkey Wrench Racing coated bearings
ARP rod bolts
New OEM Toyota main bolts
Circuitworx oil pump gear in brand new Toyota housing
Moroso baffled high capacity oil pan
OEM Toyota head gasket
ARP 2000 head studs
Monkey Wrench Racing Stage 3 cams
Monkey Wrench Racing flat face valves
Supertech valve springs
Supertech titanium retainers
New OEM valve seals
New OEM valve cover gasket
New OEM timing cover gaskets (2)
New Water pump (metal impeller)
New OEM water pump gasket
New OEM rear main seal
New OEM front main seal
Hondata Intake manifold gasket
Injector Dynamics ID1000 injectors
Apex'i PowerFC w/ commander
FC-Hako

Intake/Exhaust
2.75" Intake w/ Vibrant coupler
PPE 4-1 header
Custom rear grill exhaust - Stainless, V-band, Magnaflow muffler, polished exit pipes

Transmission
C60 6speed
KAAZ 1.5way LSD
Exedy stage 2 clutch
Fidanza aluminum flywheel

Suspension/Chassis
HKS Hipermax II Coilovers
Megan rear toe arms
Corky MSMB - "Mid-Ship Member Brace" (large center chassis brace, ties in nearly the complete middle of the car)
Corky FMB - "Front Member Brace" (ties steering rack/cross member to middle of the car)
Reinforced rear subframe
Hard Dog roll bar

Exterior
Fiberglass TRD Style aero
03-05 side vents
Stubby antenna
6000k HID kit

Interior
OMP Grip seat
OMP Corsa steering wheel
NRG steering wheel hub
Bride FG seat rail
Cusco D1 shift knob
Alpine head unit - iPod/iPhone playback
Stack ST3501 oil pressure gauge
Stack ST3509 oil temperature gauge
Stack ST3402 wideband gauge

Powder Coating
Rear subframe
Valve cover
Header (Jet Hot)

Wheels/Tires
(4) Volk TE37 16x8 +42 w/ Dunlop DZ101 205/45-16
(1) Volk TE37 16x7 +33 w/ Pirelli 205/45-16
(2) Rota Slipstream 16x7 +45 w/ Dunlop DZ101 205/45-16
(2) Rota Slipstream 16x7 +45 w/ no ties

AMD 240 · 08-24-2012, 09:06 PM

Bump for a friend!

Car is so nice.

WanganNastyMachine · 08-25-2012, 10:16 AM

Hey man, its HateSkylines on MR2OC. I can't believe your selling the car man, I remember when it was 100% stock.

GLWS for a super legit guy!

Silentoreo34 · 08-25-2012, 11:03 AM

Love this car always see it in the chi.

Bump for you sir GLWS.

singlecamslam · 08-25-2012, 02:18 PM

when i first read the post i though you had a 2jz in there haha. Nice car bump.

skyvia686 · 08-27-2012, 09:02 PM

Bump for a good guy and a legit car. Why you selling it anyways?

Nachtmensch · 08-28-2012, 02:32 PM

Thanks guys!

Quote:

Originally Posted by skyvia686

Bump for a good guy and a legit car. Why you selling it anyways?

I've had it for awhile and I want to move on to another car. The car is everything I wanted out of it. Nothing else left to do

Nachtmensch · 09-06-2012, 12:44 PM

Last bump. I added a engine bay pic when the motor went in

Flicktitty · 09-06-2012, 01:05 PM

Good luck with the sale Kevin, Hope it goes to a good owner

derek king · 09-06-2012, 01:06 PM

this is nonsense

Mofuhcka · 09-06-2012, 05:01 PM

Never liked the MR-S. Until now...

s14k · 09-06-2012, 07:26 PM

Clean ass car

1814 · 09-30-2012, 09:59 PM

Such a sick MR2!!!

theericsmith · 10-05-2012, 01:12 PM

Quote:

Originally Posted by 1814

Such a sick MR2!!!

oxymoron?
i wish you would have spent this much money on something cool :\

Nachtmensch · 12-30-2012, 09:12 PM

Bump.

Quote:

Originally Posted by theericsmith

oxymoron?
i wish you would have spent this much money on something cool :\

Guess you've never driven one, at least not with some power.

OutToWinPAHC · 12-31-2012, 07:58 AM

always loved these

08-19-2012, 11:37 PM	#1
Nachtmensch Zilvia Addict Join Date: Jul 2005 Location: Dekalb, IL Age: 36 Posts: 698 Trader Rating: (0) Feedback Score: 0 reviews	FS: 2002 Toyota MR2 Spyder/MR-S - 2ZZGE, 6spd, Kaaz LSD, HKS coils, TE37 Obviously I have a whole lot of time and money into this car. I have owned it for 4.5 years, since the chassis had 51k on it. The chassis now has 105k. The 2ZZ motor has just over 14k on it now and the car is my daily driver and has been garaged the past 3 winters avoiding any salt. The body panels need some love because the car has seen lots of track time. I warm the coolant and oil up before revving high (9000 RPM redline). The car runs on 93 octane and made 207 whp at ILL Garage. Not bad for a 1.8L in a 2250lb car Honestly, this is the most fun I have had in a car (over any other car I've driven) and it will be sad to see it go. Driving it pins a smile on me and has given me no problems. Location: DeKalb, IL Price: $18,000 as is, pricing can change by not including TE's, suspension, or engine/trans. I have well over that into this car. Email: [email protected] Engine/fuel/management Low mile 2zzge block (60k) Monkey Wrench Racing coated bearings ARP rod bolts New OEM Toyota main bolts Circuitworx oil pump gear in brand new Toyota housing Moroso baffled high capacity oil pan OEM Toyota head gasket ARP 2000 head studs Monkey Wrench Racing Stage 3 cams Monkey Wrench Racing flat face valves Supertech valve springs Supertech titanium retainers New OEM valve seals New OEM valve cover gasket New OEM timing cover gaskets (2) New Water pump (metal impeller) New OEM water pump gasket New OEM rear main seal New OEM front main seal Hondata Intake manifold gasket Injector Dynamics ID1000 injectors Apex'i PowerFC w/ commander FC-Hako Intake/Exhaust 2.75" Intake w/ Vibrant coupler PPE 4-1 header Custom rear grill exhaust - Stainless, V-band, Magnaflow muffler, polished exit pipes Transmission C60 6speed KAAZ 1.5way LSD Exedy stage 2 clutch Fidanza aluminum flywheel Suspension/Chassis HKS Hipermax II Coilovers Megan rear toe arms Corky MSMB - "Mid-Ship Member Brace" (large center chassis brace, ties in nearly the complete middle of the car) Corky FMB - "Front Member Brace" (ties steering rack/cross member to middle of the car) Reinforced rear subframe Hard Dog roll bar Exterior Fiberglass TRD Style aero 03-05 side vents Stubby antenna 6000k HID kit Interior OMP Grip seat OMP Corsa steering wheel NRG steering wheel hub Bride FG seat rail Cusco D1 shift knob Alpine head unit - iPod/iPhone playback Stack ST3501 oil pressure gauge Stack ST3509 oil temperature gauge Stack ST3402 wideband gauge Powder Coating Rear subframe Valve cover Header (Jet Hot) Wheels/Tires (4) Volk TE37 16x8 +42 w/ Dunlop DZ101 205/45-16 (1) Volk TE37 16x7 +33 w/ Pirelli 205/45-16 (2) Rota Slipstream 16x7 +45 w/ Dunlop DZ101 205/45-16 (2) Rota Slipstream 16x7 +45 w/ no ties Last edited by Nachtmensch; 09-06-2012 at 12:44 PM..

08-24-2012, 09:06 PM	#2
AMD 240 Leaky Injector Join Date: Apr 2005 Location: Lombard Illinois Age: 36 Posts: 125 Trader Rating: (0) Feedback Score: 0 reviews	Bump for a friend! Car is so nice. __________________

08-25-2012, 02:18 PM	#5
singlecamslam Post Whore! Join Date: Apr 2008 Location: Norcal Posts: 2,534 Trader Rating: (10) Feedback Score: 10 reviews	when i first read the post i though you had a 2jz in there haha. Nice car bump. __________________ Nothing says racecar like a stock car with no interior.

09-06-2012, 01:05 PM	#9
Flicktitty Post Whore! Join Date: Apr 2007 Location: Wisconsin Age: 37 Posts: 3,685 Trader Rating: (13) Feedback Score: 13 reviews	Good luck with the sale Kevin, Hope it goes to a good owner __________________ 2JZ-GTE Swapped S13 Coupe - 1994 Supra Turbo

09-06-2012, 01:06 PM	#10
derek king Nissanaholic! Join Date: May 2007 Location: in Age: 37 Posts: 1,962 Trader Rating: (6) Feedback Score: 6 reviews	this is nonsense __________________ IG DearDerekKing

08-25-2012, 10:16 AM	#3
WanganNastyMachine Zilvia Junkie Join Date: Jan 2011 Location: Maryland, USA Age: 32 Posts: 468 Trader Rating: (3) Feedback Score: 3 reviews	Hey man, its HateSkylines on MR2OC. I can't believe your selling the car man, I remember when it was 100% stock. GLWS for a super legit guy!

08-25-2012, 11:03 AM	#4
Silentoreo34 Zilvia Addict Join Date: Dec 2010 Location: Phoenix, AZ Age: 33 Posts: 630 Trader Rating: (28) Feedback Score: 28 reviews	Love this car always see it in the chi. Bump for you sir GLWS.

08-27-2012, 09:02 PM	#6
skyvia686 Zilvia Junkie Join Date: Jul 2009 Location: chicagoland Age: 33 Posts: 482 Trader Rating: (1) Feedback Score: 1 reviews	Bump for a good guy and a legit car. Why you selling it anyways?

09-06-2012, 12:44 PM	#8
Nachtmensch Zilvia Addict Join Date: Jul 2005 Location: Dekalb, IL Age: 36 Posts: 698 Trader Rating: (0) Feedback Score: 0 reviews	Last bump. I added a engine bay pic when the motor went in

09-06-2012, 05:01 PM	#11
Mofuhcka Nissanaholic! Join Date: Aug 2011 Location: Sacramento Posts: 1,810 Trader Rating: (2) Feedback Score: 2 reviews	Never liked the MR-S. Until now... __________________ @hcr32love 400whp NEO R32 Sedan

09-06-2012, 07:26 PM	#12
s14k Leaky Injector Join Date: Sep 2011 Location: summerville Age: 41 Posts: 119 Trader Rating: (1) Feedback Score: 1 reviews	Clean ass car

09-30-2012, 09:59 PM	#13
1814 Join Date: Mar 2012 Location: Chi Town Posts: 7 Trader Rating: (0) Feedback Score: 0 reviews	Such a sick MR2!!!

12-31-2012, 07:58 AM	#16
OutToWinPAHC Zilvia Addict Join Date: May 2007 Location: Florida Posts: 746 Trader Rating: (6) Feedback Score: 6 reviews	always loved these