vq35hr s13 build - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

nd240sx3 · 07-19-2011, 02:23 PM

well here we go... All of my previous 240's have been N/A ka's or ka-t, well i had a slight change of mind! this is going to be my last 240sx that i own! so i'm going all out.. well i'm going to try and go all out... so i came across a complete '08 vq35hr drive train, ecu and harness.. i got in touch with a local shop (ONE MOTION), who have done a few vq35de swaps. this is the build!

The car i started off with!

the ka that went by by!

Vq35hr drive-train

Vq35hr in! but there is a slight problem.... its crooked and the starter is sitting on the rack...

now there were a few remedies that we could of done...one raised the engine up! but then i would need a ridiculous cowl hood! two clock the rack, but the column would have a drastic bend, that would most likely bind. 3 RHD swap... now i know allot of you are going to say that there has to be a cheaper or less drastic remedy! McKinney says add a 3/4" spacer between the D/S mount and the block, but the motor then sits even worse. so a friend gave me a great deal on a complete rhd clip. In my eyes this was the best way to get it done...

Vq back out

gutted fire wall

rhd clip

Someone stole my firewall!

new firewall in place

column bracket in place

rack in!

more to come later!

07-19-2011, 02:23 PM	#1
nd240sx3 Zilvia Junkie Join Date: Feb 2003 Location: warminster pa Age: 43 Posts: 390 Trader Rating: (0) Feedback Score: 0 reviews	vq35hr s13 build new video well here we go... All of my previous 240's have been N/A ka's or ka-t, well i had a slight change of mind! this is going to be my last 240sx that i own! so i'm going all out.. well i'm going to try and go all out... so i came across a complete '08 vq35hr drive train, ecu and harness.. i got in touch with a local shop (ONE MOTION), who have done a few vq35de swaps. this is the build! The car i started off with! the ka that went by by! Vq35hr drive-train Vq35hr in! but there is a slight problem.... its crooked and the starter is sitting on the rack... now there were a few remedies that we could of done...one raised the engine up! but then i would need a ridiculous cowl hood! two clock the rack, but the column would have a drastic bend, that would most likely bind. 3 RHD swap... now i know allot of you are going to say that there has to be a cheaper or less drastic remedy! McKinney says add a 3/4" spacer between the D/S mount and the block, but the motor then sits even worse. so a friend gave me a great deal on a complete rhd clip. In my eyes this was the best way to get it done... Vq back out gutted fire wall rhd clip Someone stole my firewall! new firewall in place column bracket in place rack in! more to come later! Last edited by nd240sx3; 02-28-2012 at 04:37 PM..