IA 1990 s13 hatch sr20 stance z32 - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

QuickSpoolSR · 06-19-2012, 06:13 PM

its a 1990 se hatch with a clean title 6000 or best offer
heres my build thread
http://zilvia.net/f/chat/286453-my-s...ld-thread.html

below are the parts i remember

Engine
sr20det black top
koyo radiator
greddy front mount intercooler
powered by max intake
megan exhause manifold
real greddy turbo outlet
greddy mx downpipe
megan test pipe
greddy pe-2 exhaust
altima fans
turbo xs-rfl bov
spec stage 3 clutch
motor mounts are filled with 3m window weld
catch can
manual boost controller
z32 fuel filter
oddysey battery relocated in the trunk ran with 0 guage wire
walbro 255 fuel pump
wiring specialties s13 wiring harness

suspension/brakes
Stance gr+ pro coilovers
5 lug conversion
z32 front brakes
stainless brake lines in the front
300zx master cylinder
suspention techniques front sway bar
jic rear upper control arms
tein front tension rods
c-tune rear traction and toe rods
subframe support braces, cant remember brand
rear subframe bushings are filled with polyurethane
poly steering rack bushings
axis ultimate brake pads

Interior
sparco steering wheel
b&m short shifter
glowshift guages- water temp, fuel pressure,oil, pressure, oil temp, boost
inovoative wideband air to fuel guage- like over $200 guage
nrg harness bar
s14 seats
everything custom black
Infinity kappa component speakers in the front
infinity kappa 4x6 speakers in the rear
wired for an alpine head unit
wired for subs
white delrin shift knob

Exterior
Painted lexus starfire pearl
shaved rear wiper, antenna, side lights, and emblems
comes with black pignose lip
180sx kouki taillights

the bad:

runs, stalls out when you boost it, because of the open bov, i honestly think the engine runs good other then that
none of the suspension stuff is set, its just bolted on there, some of it loose im sure lol.

when i get over like 25 the car starts shaking, could be because of the suspension thing or because of the shitty wheels i have on it with god knows what kind of hubcentric rings.

the kouki tail lights are converted to led, but i think i bought the wrong bulbs, so you will have to figure that out

the body has nicks and chips and the roof has a pretty bad dent from a garage door coming down on it. if you had somebody buff and polish the car it would make a world of difference becuase like half the car was wetsanded but never buffed.

With some minor stuff this car could be a beast.

the car needs a little tlc, but for someone with some mechanical skills this is a steal, i just need cash right now

call or text: 515-249-5146

willing to ship at buyers expense

QuickSpoolSR · 06-20-2012, 08:34 AM

New price 5500. Need this sold

QuickSpoolSR · 06-25-2012, 08:55 AM

Found out the wobble was because the little camber bolts on my front coil over were loose. the car drives good now. also got the tail lights working. still for sale

06-19-2012, 06:13 PM	#1
QuickSpoolSR Zilvia Addict Join Date: Jul 2008 Location: des moines IA Age: 36 Posts: 756 Trader Rating: (8) Feedback Score: 8 reviews	1990 s13 hatch sr20 stance z32 its a 1990 se hatch with a clean title 6000 or best offer heres my build thread http://zilvia.net/f/chat/286453-my-s...ld-thread.html below are the parts i remember Engine sr20det black top koyo radiator greddy front mount intercooler powered by max intake megan exhause manifold real greddy turbo outlet greddy mx downpipe megan test pipe greddy pe-2 exhaust altima fans turbo xs-rfl bov spec stage 3 clutch motor mounts are filled with 3m window weld catch can manual boost controller z32 fuel filter oddysey battery relocated in the trunk ran with 0 guage wire walbro 255 fuel pump wiring specialties s13 wiring harness suspension/brakes Stance gr+ pro coilovers 5 lug conversion z32 front brakes stainless brake lines in the front 300zx master cylinder suspention techniques front sway bar jic rear upper control arms tein front tension rods c-tune rear traction and toe rods subframe support braces, cant remember brand rear subframe bushings are filled with polyurethane poly steering rack bushings axis ultimate brake pads Interior sparco steering wheel b&m short shifter glowshift guages- water temp, fuel pressure,oil, pressure, oil temp, boost inovoative wideband air to fuel guage- like over $200 guage nrg harness bar s14 seats everything custom black Infinity kappa component speakers in the front infinity kappa 4x6 speakers in the rear wired for an alpine head unit wired for subs white delrin shift knob Exterior Painted lexus starfire pearl shaved rear wiper, antenna, side lights, and emblems comes with black pignose lip 180sx kouki taillights the bad: runs, stalls out when you boost it, because of the open bov, i honestly think the engine runs good other then that none of the suspension stuff is set, its just bolted on there, some of it loose im sure lol. when i get over like 25 the car starts shaking, could be because of the suspension thing or because of the shitty wheels i have on it with god knows what kind of hubcentric rings. the kouki tail lights are converted to led, but i think i bought the wrong bulbs, so you will have to figure that out the body has nicks and chips and the roof has a pretty bad dent from a garage door coming down on it. if you had somebody buff and polish the car it would make a world of difference becuase like half the car was wetsanded but never buffed. With some minor stuff this car could be a beast. the car needs a little tlc, but for someone with some mechanical skills this is a steal, i just need cash right now call or text: 515-249-5146 willing to ship at buyers expense __________________ Last edited by QuickSpoolSR; 06-20-2012 at 01:50 PM..

06-20-2012, 08:34 AM	#2
QuickSpoolSR Zilvia Addict Join Date: Jul 2008 Location: des moines IA Age: 36 Posts: 756 Trader Rating: (8) Feedback Score: 8 reviews	New price 5500. Need this sold __________________

06-25-2012, 08:55 AM	#3
QuickSpoolSR Zilvia Addict Join Date: Jul 2008 Location: des moines IA Age: 36 Posts: 756 Trader Rating: (8) Feedback Score: 8 reviews	Found out the wobble was because the little camber bolts on my front coil over were loose. the car drives good now. also got the tail lights working. still for sale __________________