Replaced gearbox S14DET and no clutch - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

calebs555 · 02-14-2012, 03:07 AM

Took gearbox out for repair, Put it back in and the thrust bearing was not connected to the clutch fork, I put it place, by going off my mates datsun gearbox, The clutch has been bled, but the pedal just hits the floor and stays there, the clutch fork is not engaging the slave cyclinder... Is there a certain way to attach the thrust bearing? It feels like it was done right, but i cannot be positive?

Any ideas would be much appreciated!

matt2400 · 02-19-2012, 08:17 PM

Check that the cluch cooler line is not air bound

02-14-2012, 03:07 AM	#1
calebs555 Join Date: Feb 2012 Location: NZ Age: 33 Posts: 1 Trader Rating: (0) Feedback Score: 0 reviews	Replaced gearbox S14DET and no clutch Took gearbox out for repair, Put it back in and the thrust bearing was not connected to the clutch fork, I put it place, by going off my mates datsun gearbox, The clutch has been bled, but the pedal just hits the floor and stays there, the clutch fork is not engaging the slave cyclinder... Is there a certain way to attach the thrust bearing? It feels like it was done right, but i cannot be positive? Any ideas would be much appreciated!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-19-2012, 08:17 PM	#2
matt2400 Join Date: Jan 2012 Location: Suffolk Age: 37 Posts: 1 Trader Rating: (0) Feedback Score: 0 reviews	Check that the cluch cooler line is not air bound