CA 89' s13 coupe, sr20det. needs some tlc - socal - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Shwizy · 08-05-2010, 05:36 PM

I dont have the time or a place to work on my car anymore so im going to put it up for sale. This vehicle is mine and in my posession. It ran up until two weeks ago. I went to start my car and put the keys in and all my lights on the dash and overhead lamp startred flashing. Im assuming this is a short and will look at it this weekend, but for now the car will need to be towed away.

Here are the details:
'89 coupe
5 spd
all power, all works except drivers side seat belt
sunroof, no cover
unknown milage on chassis
retop sr20det approx 75k miles

MODS:
S13 front end
triple projectors
teardrop corners
fiberglass fenders
jdm metal hood
cut jdm bumper
no core support
Freddy intake manifold
T3/4 equal length cx racing manifold
Holset H1E turbo
custom downpipe
full 3" exhaust no cat
cx racing aluminum radiator w/ shroud and two 12" fans
large ebay fmic, 2.75 and 2.5" piping
stock ecu
stock injectors
stock internals
lightweight flywheel
ebay stage 3 clutch
j30 vlsd w/ 5 bolt axles installed
Z32 BMC
Z32 front calipers/rotors installed
Have the rears just not installed
NO ac
power steering doesnt work bc i cut the belt, and have yet to run new lines bc the new turbo setup got in the way.

INTERIOR MODS:
working HUD and digital cluster reading approc 145k miles
MOMO seats and sliding rails
silvia floormats

ALSO INCLUDED:
full set(4)of 18' rims (2 installed on the rear)
two 17' rims, black (on car, fronts)
two 17' rims grey

CONS:
alot, lol just being honest
I would recommend a part out or use as a drift vehicle

hole in drivers side flooring, where WG dump heated through
rust in the rear exhaust supports
cracked dash as usual
not painted - i call it the new 6-tone paint job
drivers seat only slides, doesnt recline
small leak in rear drivers side brake line
exhaust leak at the V-band of the turbo
runs way rich bc untuned
no antenna for the radio (shaved)
attempted shaving of body lines
exhaust doesnt line up quite well so its rigged
no bov installed yet, have a blitz and the alumin adapter
the Holset has an antisurge housing

Im sure ive forgotten many things. If ive missed anything please PM me

If youve gone this far im sure you want pics so here goes

thats just a few of the whole album here:
The Silvia pictures by Shwizy - Photobucket

also two videos:

FUN:
YouTube - ‪Drift Slide 240sx Basically just donuts‬&lrm;

DYNO:
YouTube - ‪Stock sr20det redtop with Holset HX40 / H1E 240sx s13‬&lrm;

232whp .8bar untuned

Thanks for looking

HachiRokuo · 08-06-2010, 01:23 AM

How much are u asking

tarmacoffensive · 10-04-2013, 11:51 AM

bumpity bump bump

08-05-2010, 05:36 PM	#1
Shwizy Join Date: Oct 2009 Location: Oceanside, CA Age: 37 Posts: 16 Trader Rating: (0) Feedback Score: 0 reviews	89' s13 coupe, sr20det. needs some tlc - socal I dont have the time or a place to work on my car anymore so im going to put it up for sale. This vehicle is mine and in my posession. It ran up until two weeks ago. I went to start my car and put the keys in and all my lights on the dash and overhead lamp startred flashing. Im assuming this is a short and will look at it this weekend, but for now the car will need to be towed away. Here are the details: '89 coupe 5 spd all power, all works except drivers side seat belt sunroof, no cover unknown milage on chassis retop sr20det approx 75k miles MODS: S13 front end triple projectors teardrop corners fiberglass fenders jdm metal hood cut jdm bumper no core support Freddy intake manifold T3/4 equal length cx racing manifold Holset H1E turbo custom downpipe full 3" exhaust no cat cx racing aluminum radiator w/ shroud and two 12" fans large ebay fmic, 2.75 and 2.5" piping stock ecu stock injectors stock internals lightweight flywheel ebay stage 3 clutch j30 vlsd w/ 5 bolt axles installed Z32 BMC Z32 front calipers/rotors installed Have the rears just not installed NO ac power steering doesnt work bc i cut the belt, and have yet to run new lines bc the new turbo setup got in the way. INTERIOR MODS: working HUD and digital cluster reading approc 145k miles MOMO seats and sliding rails silvia floormats ALSO INCLUDED: full set(4)of 18' rims (2 installed on the rear) two 17' rims, black (on car, fronts) two 17' rims grey CONS: alot, lol just being honest I would recommend a part out or use as a drift vehicle hole in drivers side flooring, where WG dump heated through rust in the rear exhaust supports cracked dash as usual not painted - i call it the new 6-tone paint job drivers seat only slides, doesnt recline small leak in rear drivers side brake line exhaust leak at the V-band of the turbo runs way rich bc untuned no antenna for the radio (shaved) attempted shaving of body lines exhaust doesnt line up quite well so its rigged no bov installed yet, have a blitz and the alumin adapter the Holset has an antisurge housing Im sure ive forgotten many things. If ive missed anything please PM me If youve gone this far im sure you want pics so here goes thats just a few of the whole album here: The Silvia pictures by Shwizy - Photobucket also two videos: FUN: YouTube - ‪Drift Slide 240sx Basically just donuts‬&lrm; DYNO: YouTube - ‪Stock sr20det redtop with Holset HX40 / H1E 240sx s13‬&lrm; 232whp .8bar untuned Thanks for looking

08-06-2010, 01:23 AM	#2
HachiRokuo Join Date: Jul 2009 Location: near bakersfield Age: 40 Posts: 17 Trader Rating: (0) Feedback Score: 0 reviews	Ummm How much are u asking

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-04-2013, 11:51 AM	#3
tarmacoffensive Join Date: Sep 2013 Location: chicago Age: 28 Posts: 12 Trader Rating: (0) Feedback Score: 0 reviews	bumpity bump bump