Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > S Chassis

S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15.


Reply
 
Thread Tools Display Modes
Old 11-27-2011, 06:59 PM   #1
projekt_goldfish
 
Join Date: Nov 2011
Location: SD
Age: 35
Posts: 14
Trader Rating: (0)
projekt_goldfish is an unknown quantity at this point
Feedback Score: 0 reviews
Exclamation Any help please!!

OK heres the story!
i have a 92 hatch with an sr20 swap. ive been try to fix this problem for over a month with no sucess it all started when i was doing a compression test.(150 on all cylinders btw) then sparks went flying somewhere around my starter. then it wouldnt start. its push starts fine but after it runs for a while the gauges start goin nuts and dimming.

here is what ive done:
replaced the starter
tested the alternator(good at 14.8v)
replaced the battery
replaced the battery cable(bat. located in the trunk)
checked the fuses and relay(good)
getting 0v at starter signal wire(trying to trace back to ecu)

wondering:
how to check the ignitor chip.
how to test ignition switch in steering column.

any other ideas?
projekt_goldfish is offline   Reply With Quote
Sponsored Links
Old 11-28-2011, 10:51 PM   #2
trsebert
 
Join Date: May 2011
Location: Grovetown, GA
Age: 37
Posts: 32
Trader Rating: (0)
trsebert is an unknown quantity at this point
Feedback Score: 0 reviews
which fuses and relays did you check? Because there are several different relays and fuses that you will have to check. Honestly i would check most of the relays and fuses in the engine bay, and there is also the ignition relay that alot of people miss that is sitting up underneath the fender (but inside the engine bay on passenger side, blue). Also, testing the ignitor chip is pretty simple, but I don't think this is your problem. You probably blew a fuse, or relay, or burnt up a wire somewhere. Happy hunting.

You can check the ignitor chip for voltage and continuity with a voltmeter, and take off the lower cowling of the dash and steering column and that should give you nice and easy access to the ignition switch.
trsebert is offline   Reply With Quote
Old 11-30-2011, 10:19 AM   #3
nissanfreak317
Zilvia Junkie
 
nissanfreak317's Avatar
 
Join Date: Apr 2008
Location: Souderton, PA
Age: 38
Posts: 597
Trader Rating: (18)
nissanfreak317 is an unknown quantity at this point
Feedback Score: 18 reviews
Sounds like a dead short somewhere. Disconnect your battery and do continuity tests from ground to starter power wire maybe? A visual check should show worn wires and black spots from arcing if this is the issue. It would be near your starter if that's where you saw sparks.
nissanfreak317 is offline   Reply With Quote
Reply

Bookmarks

Tags
ignition, problems, s13, sr20, starter



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:28 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net