Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > S Chassis

S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15.


Reply
 
Thread Tools Display Modes
Old 02-11-2019, 11:02 AM   #1
Magoo1222
Zilvia Junkie
 
Magoo1222's Avatar
 
Join Date: Jun 2013
Location: Upstate New York
Age: 30
Posts: 398
Trader Rating: (8)
Magoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura aboutMagoo1222 has a spectacular aura about
Feedback Score: 8 reviews
S13 HOW TO: Fix for dash lights not working (fried TCU)

The other day, the dash lights randomly stopped working in my s13 (gauge cluster, dash buttons, HVAC, the whole shebang). After checking the fuses and confirming that power was getting to the bulbs, I did a bit of research and concluded that the problem was with the Timing Control Unit (the little white box located next to the fuse box, behind the driver side kick panel). While this is a known problem, I could not find any good documentation on the repair, so here you go.

Step 1)
Remove the driver side door sill plate and driver side kick panel to expose the TCU


Step 2)
Open the unit by pushing in the 4 plastic tabs with a screwdriver and slide the circuit board out of the case (be gentle when prying, the plastic is old and brittle, I ended up breaking one of the tabs in the process).


Step 3)
At this point, it will likely be obvious if the TCU is indeed your culprit, as the inside of the case will smell horrid (burned circuitry). Take a close look at the board for any obvious burned components and traces. In my case, this large trace on the end of the board was completely fried.


Step 4)
Using solder wick or a solder sucker, remove the old solder at each end of the trace, as well as any pieces of the copper trace left intact. Then clean the burned residue with rubbing alcohol in preparation for the repair.

Step 5)
Using a light gauge wire (I used 18 gauge as it is what I had handy, it doesn't need to be anywhere near this heavy gauge, but it will do), bridge the pins that used to be connected via the trace.


Step 6)
Reassemble the board into the case and reinstall into the car. Enjoy your functional dash lights once more!

Last edited by Magoo1222; 02-11-2019 at 10:33 PM..
Magoo1222 is offline   Reply With Quote
Sponsored Links
Reply

Bookmarks

Tags
240sx, dash lights, fix, s13, tcu


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 02:04 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net