Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > Z Chassis

Z Chassis Technical discussion related to the Z Chassis such as the S30, S310, Z31, Z32, Z33 and Z34.

Thread Tools Display Modes
Old 02-25-2015, 07:27 PM   #1
Leaky Injector
justin_bfn's Avatar
Join Date: Aug 2012
Location: ohio
Posts: 50
Trader Rating: (0)
justin_bfn is an unknown quantity at this point
Feedback Score: 0 reviews
isis hydro in a z33

I recently bought a new Isis hydro for my 350z and when putting it in I assumed (first mistake) it was like a 240 and you could cut into factory lines and feed it from there. Wrong. So after countless hours of replacing the cut brake lines, I went by a DIY'er on here like myself and got braided lines and hooked them up the right way and swapped the right lines at the abs block I figured this looked right. So I bled, and bled, and bled. Just drove it and my pedal goes to the floor practically. And my hydro will build pressure then lose it like theres a leak. But there isn't. Master level is still the same and there were no spots on the ground from possible leaks. The only thing I haven't done is bleed the hydro itself mainly because I don't know how other then to take the lines back off and physically pump fluid into it so there is no air. So what am I missing here? Any guidance at all would be appreciated. Mixed up lines where I had to redo them? Not sure.
justin_bfn is offline   Reply With Quote
Sponsored Links


350z, hydro ebrake, isis, z33

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 02:51 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Copyright © 1998 - 2019, Zilvia.net™