Quote:
|
Originally Posted by brrr
Hey, I am doing an s14 sr into s14 96 240sx and I have the complete wring harness and the jdm ecu. There are four plugs on the inside-of-the-firewall end of the harness, the ecu plug, another large plug (which is obvious where it goes so ok), and then 2 blue relay plugs. On the 240sx harness though there is one blue relay plug, and then this 8wire little white plug that attatches to a plug that seems to run to the back of the car. What to I do with this difference? I found which of the 2 relay plugs match up, but I am left with an unaccounted for relay plug on the sr harness and a empty white plug in the car. what should I do?
|
mod said no questions.. fuk man read..
bigass letters
DO NOT POST IN THIS THREAD UNLESS YOU HAVE AN ANSWER TO A FAQ!
-incase of hotpipe clearance issue
to add; If you want your SR hotpipe to sit LOWER(S13 SR), use a S14 turbo inlet pipe..
hotpipe /w bov sits nice and low.
s14 inlet pipe is shorter then s13 inlet pipe.