View Single Post
Old 06-06-2012, 04:12 PM   #51
slideways240
Leaky Injector
 
Join Date: Mar 2003
Location: columbus-ohio
Age: 43
Posts: 107
Trader Rating: (0)
slideways240 is an unknown quantity at this point
Send a message via AIM to slideways240
Quote:
Originally Posted by racinjayson View Post
This maybe a silly question, but do you think that there is a possibility of removing the bell housing to machine off the extra thickness and run an s14 flywheel? Or since that might misalign the starter, take the bell housing and section an inch out of it at the base which would pull the tranny closer without messing with the starter aliment. I think I'm going to try this and get back to this thread to report my findings because a 17lbs flywheel is just unacceptable when with the s14 setup you can have a 9.5lbs flywheel.
An easier solution would be to use something like the Exedy hyper single. The included flywheel is not dual mass and extremely light comparatively. Also I can second the other S14 owner. Removal of the tranny alone is doable in an S14 chassis, it's a pain though.
slideways240 is offline   Reply With Quote