View Single Post
Old 09-07-2012, 06:31 PM   #1
SilviaT
Zilvia Member
 
Join Date: May 2011
Location: NW Oregon
Posts: 166
Trader Rating: (0)
SilviaT is an unknown quantity at this point
SR Pilot bushing issue sr20det

So Im having a issue installing my input shaft into the flywheel on my freshly rebuilt sr20det with a new spec stage 2 clutch kit. So I got my engine into the bay all nicely but it just isn't popping into place.. Anybody else having this issue? Or advice? Should I shave off a little bit of the pilot bushing because it's a HELL of a tight fit! After that it should be a piece of cake.
SilviaT is offline   Reply With Quote
Sponsored Links