|
Theres no reason to move the head...
Remove lower and upper oil pan...(remove motor mount bolts to halp lift the motor up to gain clearence to get upper pan out)
Now u have full access to the rods.
Spin crank to rear 1 rod at a time..verift the cap is backwards. Remove both nuts and flip the cap. Torque and repeat.
If changing bearings do the same, but tap the rod up by the stud with a brass hammer or wood dowel(not to damge threads) pop the bearing out. Reinstall upper bearing half and pull the rod back down, make sure the bearing is seated properly in the rod. I stall bottom bearing into the cap. Then install bearing and cap in THE PROPER ORIENTATION. torque to spec and reinstall pans, mounts and oil.
|