http://zilvia.net/f/showthread.php?t=658417
Quote:
Originally Posted by outfronts13
I had a major issue when torquing down my new ARP head studs for my SR. The instructions given to me by ARP stated to torque the nuts in three equal steps to 90ft lbs. I followed the instructions, yet one of my studs stripped into my block at 60 ft lbs. Do i do a helicoil kit install in the hole??. This is so frustrating
Sent from my iPhone using Tapatalk
|
Sheesh... talk about timing... wonder if there was an out break...
Also, to be noted I have only used ARP flywheel bolts on my SR and 600 miles in they're just fine and went in no problem. Got them from JGY as they were in stock, so I don't know how old of stock they were.