Since all the pictures under the car pretty much look the same/similar angle. It doesnt look like much of an update but here goes!
Before undercoat.
After undercoat.
Got my fittings, hose, and hose separators.
The line separators are 6an size.
What the end of the hardline will look like.
Started by cutting the lines and slipped some fuel hose over for the clamps and the tube nut flares.
Then the flare clamp.
Both Flared.
Nipples
Wrenches. (I asked myself why i'm taking a picture of wrenches while laying under a car, out loud, I thought I heard a voice answer....)
Tighten them down.
Line Separators.
One line measured to tank, pushed on and clamped.
Both lines clamped and clamped to the tank.
After hooking the tank i put the other line separators on.
I ended up needing to re-flare the connection with a double flare as it leaked from the pressure. So after that was fixed, I fired the car up.
I have started on the subframe again and hope to have it back together soon! With Pictures!