My SR20VET is soo close. I'm just awaiting a 82.5mm throttle body from RMR, my ebay one i bought was leaking bad out the Shafts on the sides (tps/Throttle body).
I have a few questions.
The front of the valve cover hits the hood pretty hard, what motor mounts is everyone running to space the engine down a little bit?
Also is there any other throttle bodies available other than RMR 82.5mm. I can't seem to find anything else and a stock q45 throttle body won't work because it is too long. I need a throttle body about 2" long.
I can't wait to rail this setup!!
I hope to do about 500whp then tune it down to 450whp.
I plan to run pump gas, and around 15-20psi. Any guesses on what she will do around that, i'm super anxious to get her on the dyno.
AEM VER. 2 ECU
P11 Head with N1 Cams & BC Springs & Retainers
Mazworx intake manifold with 82.5mm RMR Throttle body
1000cc ID's w/ Water Meth injection
ls7 Coilpack w/ built in heat sync
Future Fab Manifold w/ GTX3076 . 82 ar
CP Pistons w/ valve releifs 9:1 and Manly Rods
ATI crank pulley
VE Oil Pump
all on Stock SR Transmission w/ OS Giken Twin Disk.