Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - 1UZFE into S-Chassis

Jifter · 10-01-2013, 07:03 AM

I dont think there should be a gap between the pressure plate and bearing. That way you dont have play in the clutch pedal. I can tell you that to extend your bearing slider, you need to cut your 2nd slider just bellow the two tabs. Then weld it on top of your other un-cut slider.

10-01-2013, 07:03 AM	#113
Jifter Leaky Injector Join Date: Oct 2010 Location: Mississauga, Ontario Age: 33 Posts: 51 Trader Rating: (0)	I dont think there should be a gap between the pressure plate and bearing. That way you dont have play in the clutch pedal. I can tell you that to extend your bearing slider, you need to cut your 2nd slider just bellow the two tabs. Then weld it on top of your other un-cut slider.