View Single Post
Old 12-24-2009, 06:04 PM   #41
95KA-Turbo
Post Whore!
 
95KA-Turbo's Avatar
 
Join Date: Jul 2005
Location: LA
Age: 38
Posts: 3,402
Trader Rating: (19)
95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of95KA-Turbo has much to be proud of
Ideally you would have an adjustable LCA with a spindle that corrects geometry, so you can fine tune it with the LCA and the knuckles could adjust like 30mms or so.

A way to bypass the whole tension rod issue is to get rid of the 2 prong bolt on method and make a LCA with a bracket to allow a double heim joint tension rod. So you can weld it on however higher or lower depending on what you do with the inner LCA pick up point.

Something similar to this:





A company called SP-Tec in Japan makes these:



__________________

Instagram - SJKnoop
95KA-Turbo is offline   Reply With Quote