View Single Post
Old 06-18-2021, 04:52 PM   #16
dan_the_drifter
 
Join Date: Mar 2019
Location: Devon, uk
Age: 32
Posts: 36
Trader Rating: (0)
dan_the_drifter is an unknown quantity at this point
Right so onto the rears, these are very quick and easy to fit, again excuse the mud and dirt:

Jack up and axle stand as before:

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

Undo the lower shock bolt, don't slide it off yet though if not it will drop when you undo the tops.

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

Now undo the top bolts...

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

You will notice I have twin calipers so just have to cut the cable tie holding the extra brake line then lever the lower off with a bar as it will have some (not very much) force holding it. Then wiggle it out.

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

Something I was quite surprised by was the thickness and length of the MaXpeedingRods shock and springs, this should allow more travel (more grip possibly) whereas on the front of the car I'm fairly sure I will have less travel due to the shorter body...

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

Whilst the coilover was out I did a quick clean of the area, before:

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

After:

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

That's a bit more like it

And new one slotted back in:

Rear MaXpeedingRods coilovers by Daniel Collins, on Flickr

There we go, so I should be trying these out in exactly a month from today at a local car show, hoping to align the car again before that happens. Also have a drift day sharing a friends car next weekend so that should be fun.
dan_the_drifter is offline   Reply With Quote