Quote:
Originally Posted by driftage240
Yup I installed the cooler and everything went down south, I can't see me having a air leak since I tefloned all the ends on the set up... I dunno what else to do, I did bleed it properly because it worked like a charm prior to installing the cooler..
|
If you teflon taped the ends of your AN fittings (or ANY flare or o-ring seal) thats an issue. :\ Thats bad. SOMETIMES luck will be on your side and it will work...but more than likely it will leak. AN fittings flare with a 37 degree flare, if that teflon tape keeps the cone from seating on the opposite end fitting, you have an air passage. There is cases where air will pass through but fluid wont (PS fluid is thick) The same goes for O-ring fittings, like the ones that thread into the rack.