Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - Skullworks

240sxTTE · 02-27-2010, 09:44 AM

Just in case anyone else has -10 lines. All of my lines and fittings are -10 so I didn't want to change my lines to -8's. I have a lot of lines with the oil cooler and Accusump. I measured the center-to-center on the oil adapter block and found it is about 0.020" too narrow for -10's to fit side-by-side. Anyways I didn't want to cut 0.010" off the edges of each hex so I figured out that staggering them would work. I used one of the fittings that came with the block, one -10AN to -8 straight ORB adapter (Summit# EAR-AT985009ERL) and one -8AN to -10AN adapter (Summit# SUM220223-B). Hope this helps.

BTW - great oil adapter block Juan!

02-27-2010, 09:44 AM	#82
240sxTTE Leaky Injector Join Date: May 2006 Location: Ohio Posts: 73 Trader Rating: (3)	Just in case anyone else has -10 lines. All of my lines and fittings are -10 so I didn't want to change my lines to -8's. I have a lot of lines with the oil cooler and Accusump. I measured the center-to-center on the oil adapter block and found it is about 0.020" too narrow for -10's to fit side-by-side. Anyways I didn't want to cut 0.010" off the edges of each hex so I figured out that staggering them would work. I used one of the fittings that came with the block, one -10AN to -8 straight ORB adapter (Summit# EAR-AT985009ERL) and one -8AN to -10AN adapter (Summit# SUM220223-B). Hope this helps. BTW - great oil adapter block Juan!