well first I needed to clean up the area to weld. again im not a pro at this but I figured id give it a go. the idea was to cut some steel plates and weld over the cracked seams as close as possible. I do have professional 3m panel cement but where would one start with that?
well this is what I was able to do, then my welder feed took a shit on me. so I need a new torch and a drive wheel. can't be too mad it is a cheap eastwood welder that I've had for like 3 years so im not too peeved.
on the other hand it still looks like shit and now im at a loss on what to do?
well what do you zilvian body wizards recommend? im guessing I need another strut tower assembly