View Single Post
Old 05-15-2017, 11:35 PM   #14
WheelWhore
Zilvia Addict
 
WheelWhore's Avatar
 
Join Date: Jan 2010
Location: NC
Age: 37
Posts: 724
Trader Rating: (4)
WheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymoreWheelWhore is not welcome here anymore
Quote:
Originally Posted by drift freaq View Post
The height of the mount or how high it makes your engine sit? Nismo mounts raise your engine up about an inch my mounts will drop your engine down about 1/2 inch to 3/4 of inch though the oil pan will not sit below the crossmember. I am not sure how deep the 2j pan runs in comparison to KA or SR pans. If you want a set of mounts that are not going to rattle your teeth then you will want my mounts.
My mounts are right around 2 and 3/4 inches tall.

Hows ground clearance on a Greddy Pan w/ a Red Top? I need about a 1/2" lower than OE. My Downpipe keeps hitting my floor pan and Im not going to be bashing it in.

Also assuming I am having this issue as my trans mount seems done too.
WheelWhore is offline