[k00laid83]

Update:

Well the heads were dropped off with the machine shop on Friday. I'm having them clean and resurface/deck the heads. I'm having them install all the valve seals that came with my subaru gasket kit and having my comp clutch flywheel resurfaced. I had them clean the valve covers as well while I was it. They advised that I should have everything by the end of this week.

I switched the short blocks out on my engine stand. My new short block is ready to start rebuilding. I'm glad I listened to everyone on here and on facebook groups about just picking up a new short block. It looks damn good! I started installing some of my parts. I installed a new 11mm STI oil pump, new baffle plate, a moroso oil pick up and new oil pan. The plan is to clean most of the hard lines this weekend and clean out anything that might have bearings particles in it.



















I gotta wash my poor 240sx!!