Thread
:
Project: SteeZee - 1973 Datsun 240Z LQ9 V8 Build
View Single Post
01-13-2014, 07:03 PM
#
36
Aaj2k5
Leaky Injector
Join Date: Sep 2005
Location: Kitchener, Canada
Age: 34
Posts: 55
Trader Rating: (
0
)
Same old game - days off getting farther apart and I'm going to McMaster part time to finish my B.Tech.
Updated the Solidworks model with cage:
Plated the rear strut tower tops and fitted the rear tower member of the cage. Also cut out the rear floor to the frame rails so I can start on fuel cell frame.
Hit up BendTech for the main hoop - thanks Joe!
Cut the main hoop base at ~9 degree angle towards the rear so it sits flush at base when hoop was in place. This is a temporary fastener for subframe btw - inverted socket head shoulder bolt will be the final.
Didn't wanna waste $100 on a lift plate - cut piece of scrap 1/4"x6"x18.5" plate, drilled 10 holes, zipped two 1" pieces of scrap pipe, ground flats on each of them to sit square and just need to weld er up. $2 lift plate (cost of fasteners haha)
Last edited by Aaj2k5; 09-03-2018 at
11:11 AM
..
Aaj2k5
View Public Profile
Find More Posts by Aaj2k5