Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

doitsidewayz · 07-13-2012, 03:24 PM

installed my z32 diff last night. pretty easy no big deal. used j30 axles. and used the j30 axle bolts.(from diff to axle bolts). used the s14 drive shaft bolts ( diff to drive shaft bolts). okay today after driving it i noticed at low RPM when i accelerate i hear a clunk. i checked all the bolts. diff to axle, diff to drive shaft and axle nut bolts. they all are nice and tight. i did notice the bolts that go where the diff has the bushing seemed to go all the way up. there is a little gap in between. i tried tightening them but that's as far as they would go. any ideas...?

07-13-2012, 03:24 PM	#1
doitsidewayz Zilvia Addict Join Date: Jul 2011 Location: -_______- Posts: 714 Trader Rating: (1)	people runnig z32 diff's help me out installed my z32 diff last night. pretty easy no big deal. used j30 axles. and used the j30 axle bolts.(from diff to axle bolts). used the s14 drive shaft bolts ( diff to drive shaft bolts). okay today after driving it i noticed at low RPM when i accelerate i hear a clunk. i checked all the bolts. diff to axle, diff to drive shaft and axle nut bolts. they all are nice and tight. i did notice the bolts that go where the diff has the bushing seemed to go all the way up. there is a little gap in between. i tried tightening them but that's as far as they would go. any ideas...?