Starting paint prep on the car this coming weekend so I've gotta get the drop vent done asap! Going with the expanding foam technique. Hopefully it works!
Surgery time!
I made a grid to hopefully keep things as square as possible
Looks nice and ignorant just how I like
I wanted to see how this process would work, so I built in a ton of extra space so I can decide if I'd like to make a negative or a positive mold once it's all cured and ready to be shaped. 6 hours of cardboard and tape play later...
And after 20 minutes of frantic foam-mixing and pouring...
I actually missed taping up a spot to the front and the foam started pouring through the engine bay (you can see where the foam is kind low on the near side) lol hopefully it didn't get on anything that'll be too difficult to clean up! I think most of it just ended up on the ground.
