Quote:
Originally Posted by DEGUZZI
The smallest bit I have is 1/16", and it doesn't quite fit through the orifice.
If it's relevant, the opening originally is 5/64", then tapers to the <1/16"
|
Thanks much. I shoved the smallest plastic vacuum fitting I had into the line (maybe 3/32 or 5/64 or 2mm ID?) and it helped. I'm going to make an even smaller fitting.. I don't have any bits that small either but I could get a nylon screw and maybe use a heated piece of 16 or 18 gauge wire to 'drill' a hole through it.