Quote:
Originally Posted by Kylerkickass240
What's the process like for making the gas door flush with overs? I don't know if I've ever seen it done irl before but I always thought "man it would look so much better if it was".
This is an awesome thread to follow btw, thanks for documenting the build!
|
Thanks, Its fun to share.
So the opening in the overfender was too small for the gas door to even fit. So it was sectioned to allow it to open and then reinforced on the back side.
I 3d printed some temporary standoffs to get the right height. On final installation I will make a proper bracket.
-Jordie