Quote:
Originally Posted by t0xic_ruin
What would you recommended for piston ring end gap? currently putting my Ka-t together and ive seen people say to gap the rings more than the stock but havent found anything saying how much to gap them.
My setup is basically the same, enthalpy tune,bottom mount t25, 370cc injectors, z32 maf looking to make 250-280 hp
|
Assuming you're using OEM pistons/rings here? If you're using aftermarket pistons, use their ring card/specs. nearly every manufacturer provides gap values based on intended use for the engine in a simple formula by piston diameter. Otherwise;
http://letmegooglethat.com/?q=KA24DE...M+piston+rings
First link that pops up there. If you searched you didn't search very hard. .017-.018 top .019-.020 bottom for stock bore. The gap depends on whether you're overbored or not FWIW.