Small update. Wired in a keyless entry setup and shaved the key cylinder on my door handles. 3D printed a plug and epoxied it in on the backside of the handle.
Started messing around with the ride height and tested different wheels. Pictured below is 15x9 -15 with a 195/55. Will probably end up with a 0 offset up front and keep the -15 in the rear with a bit more camber. Wheels are all going out for sandblasting next week.
Finished the glass/filler work on the aero and shot some primer. Started hard mounting it all to make sure the fitment is spot on. Waiting on the final aero piece to show up from the motherland.
Heading to Japan for two weeks at the end of the month. Car is scheduled for paint the weekend I return. Its crunch time for this bodywork!