Quote:
Originally Posted by Croustibat
I use both a thermal switch switch with a manual override AND a probe type. If one fail, as it happened already (sensor did not but the GND wire went loose on the switch. I could still overrride it but it was a pain), the fans can still run.
|
I mean 2 is better than 1 but from a stand point the fan controller is calibrated with said sensor whether probe/NPT. Over ride switch for sure is needed in case of fan controller failure. If anything i will use my temp coming from upper rad hose since that’s most accurate and I’ll probe the rad and use that to control fans (based off the temp on my EVDM)
Sent from my iPhone using Tapatalk