Quote:
Originally Posted by dsamani
Also, my engine load changes with throttle, as per the docs this indicates a problem with my MAP wiring but I can't figure it out.
|
^^^^^ i had the same problem (RB25) the car would pop but not start. the wiring harness i had made ended up being wired wrong and fried the sensor. Called AEM and they said "no MAP no start. the engine load changing with throttle is a fail safe to not blow your motor"
hope this helps.
Also, playing around with the injector battery offset then cranking your motor is a good way to fry your injector drivers and cause board damage.