Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

homegrowngarage · 12-23-2014, 11:14 PM

Next set of pictures is here!

The garbage interior is finally all stripped and ready to be bedlined.

Floor is completely cut up and ready for new patches

Sitting pretty

Small patches in the trunk area. Grinded them down and will seam seal over it before painting.

Sealed.

The only thing that keeps us in the garage during the winter. Keeps us nice and toasty

More cutting on the patches.

Painted the floor with Rusteolem Bedliner

Test fitting the bucket seats.

VTEC JUST KICKED IN YOO!

Starting to come back together

Just installed those mad tight hydraulics…. Actually lifting the car up so we can address the frame rail and other rust areas. Probably not the safest method but it works

Taking a break

Little gap in the pictures here, but here we are in the middle of fabbing up the tubs. The trailer fender was cut in half and each piece was attached to the strut tower. Our goal is to have the extra room in the wheel well, and also make the tub look good(not a bag of dicks)

Welds are starting to get better

Left side tacked in

Tubs….

Oops..

12-23-2014, 11:14 PM	#8
homegrowngarage Leaky Injector Join Date: Dec 2014 Location: Allentown, PA Posts: 117 Trader Rating: (0)	Next set of pictures is here! The garbage interior is finally all stripped and ready to be bedlined. Floor is completely cut up and ready for new patches Sitting pretty Small patches in the trunk area. Grinded them down and will seam seal over it before painting. Sealed. The only thing that keeps us in the garage during the winter. Keeps us nice and toasty More cutting on the patches. Painted the floor with Rusteolem Bedliner Test fitting the bucket seats. VTEC JUST KICKED IN YOO! Starting to come back together Just installed those mad tight hydraulics…. Actually lifting the car up so we can address the frame rail and other rust areas. Probably not the safest method but it works Taking a break Little gap in the pictures here, but here we are in the middle of fabbing up the tubs. The trailer fender was cut in half and each piece was attached to the strut tower. Our goal is to have the extra room in the wheel well, and also make the tub look good(not a bag of dicks) Welds are starting to get better Left side tacked in Tubs…. Oops.. More to come in the next post! Last edited by homegrowngarage; 05-06-2015 at 10:15 PM..