[jubee]

So I'm gonna put this out there so nobody else makes the mistake I did. I don't know about the 2j manual trans, but for the auto trans make sure you attach your starter before putting the motor in your engine bay. Cause there is no room to feed the bolt at least the top hole. Bottom one I might be able to hammer the tunnel a little bit.



So just putting that out there for info so others don't make my mistake, of course I was thinking that I could just install the starter later. But jokes on me haha.


Also again for the guys running auto looks like you are gonna have to make your own transmission lines cause that stock hard line is not going to fit correctly.

so just giving a little info on the little things that are never told.