PDA

View Full Version : SR20DET wiring problems


N1ghtK1d_D
11-01-2005, 09:33 PM
I'm almost done with my SR20 swap in my 91 240sx and i came along a little problem. i was pluggin in the wiring harness when i notice the connector to the Throttle position sensor doesnt fit. the plug is 6 prongs while the outlet it connects to is a outlet for a 3 prong connect. is this common? i have yet to read up on this. if anyone has ran into this problem before can you please post up your solution? after this my car will be ready to run 2 days later. the sooner i hear feedback, the better. thanks

HIGHMILEHATCH
11-01-2005, 10:48 PM
Can you post pics? Your TPS plug on the harness should be brown if this is a redtop. Is it?

N1ghtK1d_D
11-01-2005, 11:08 PM
http://img.photobucket.com/albums/v622/bladetrinity/my%20car/aaaa.jpg

its a shitty pic but my camera died right after this pic. the cirlced connector is the 6 prong piece and the arrow is pointing to where it goes. the tps connector is 3 prongs liek its suppose to be so idk about this harness.

Powerslide7
12-09-2005, 03:33 PM
i ran into the same prblem....what gives....mine is a black top... si there i differece btween the plugs for the auto vs. the 5spd. tps.????

iamwesley
12-09-2005, 04:58 PM
U have an automatic harness. and a Manual TPS. U can wire it up. Look for the diagrams on fresh alloy.