top mount turbo question

[TheSparo]

what are the thread sizes for the oil lines for the feed and drain lines? also is there anything tricky that i should know about while removing/installing the old/new parts? oh and this is on a red top SR20...
thanks

[DoriftoSlut]

Depends on the turbo you are running. Usually -3 AN oil line from the block to the turbo. 5/8 inch heater hose oil drain. Need -3 AN/1/4 inch (i think) fitting for the block and turbo and the oil drain fitting for the turbo.

[Maeda]

You might want to use WD40 as the exhaust side of the motor is ALWAYS FUCKING HEAT CORRODED and is a bitch to take off.

Otherwise what DoritoSlut said(even though he takes it in the butt doesn't mean he doesn't know what he's talking about).

[TheSparo]

i meant the thread pitch it took into the block, like 12x1.25 or sometihng? i just wanna make sure i got the correct parts in my oil kit :)
thanks all