intake install, where to put ATS?

[86LXItooFAST4me]

ok, i got this cheapo cone filter and adaptor for the stock intake:
http://i18.ebayimg.com/03/i/03/03/f3/6d_1_b.JPG
but as i was about to take the airbox out i noticed a sensor. did some searching on here and the only thing i could find basically is that its a Air Temp. Sensor. but didnt find out anymore info. there is no place to put it on the cone filter or the adaptor so my question is, what do i do with the ATS? im sure i need it right?

95 S14 KA24

[projectRDM]

IAT is only used for OBD purposes, you can tie it to the harness anywhere near the filter.

[86LXItooFAST4me]

you mean tie it into the intake anywhere or do you mean disconnect it and let it hang?

[Ritz S14]

Tie it near the filter. Do not disconnect it.

[86LXItooFAST4me]

you mean just like rig it to where the sensor is sitting outside the filter?

[Ritz S14]

Outside, close to.. just make sure it's near to the air filter.

[Drunk Bastard]

or you could put a resistor in, tape it up, mount it up, then use and obdII reading tool and erease the CEL....thats what i did.

[86LXItooFAST4me]

cool, thanks guys

[Zushi]

sorry to steal your thread but I have an ARC intake box that doesn't clear the hood. Can i just buy a filter at autozone,nappa, oreilys that will bolt right up to the adapter?