PDA

View Full Version : so if you use seafoam on an SR...


TheSparo
08-03-2004, 09:42 PM
would it totally fuck up your turbo? bc ive heard seafoam takes all the carbon buildup off of the top of the pistons... but it goues out the exhaust... and when you have a turbo...
any input?

mrmephistopheles
08-03-2004, 10:44 PM
it'd go out the exhaust side of the turbine.. dunno!

ftrs13
08-03-2004, 11:42 PM
it would probably be like running rich for a while, people run rich all the time with turbos ... so Im guessing not, but wait for some more input :)

240sxconversion
08-04-2004, 10:35 AM
if seafoam is the same stuff as the used on 2 Guys garage, they used it on a grand national which is turbo. http://www.run-rite.com/ this is the stuff i am talking about.

noahrexion
08-04-2004, 10:54 AM
It wont hurt a dang thing.... <---- 3 bottles in SR 4 me :p

uiuc240
08-04-2004, 11:06 AM
stuff is awesome. i'm going to run another can through mine this weekend.

Eric

sr240mike
08-04-2004, 07:03 PM
arent you supposed to change plugs and oil immediately after using it? Ive used it on my Z. My neighbors were pissed with the smoke cloud covering the street. (condo)

TheSparo
08-04-2004, 07:12 PM
ok, so it wont hurt?
how much do you put everywhere again? a bottle through the gas tank, bottle in oil, and how much in the brake booster ?

uiuc240
08-05-2004, 07:36 AM
it's all written on the side of the can. when you pop the brake booster line off, have someone in the car ready to apply throttle, as it will stall the car. also, i found that a good way to get the fluid in there was to use a small glass measuring cup, tip it slightly toward the vacuum hose, and then just let the hose suck the fluid in slowly. yes, the cloud was nasty...but it was worth it. and by the way, you only need one can to get the job done. do it again in a couple of weeks if you need more.

TheSparo
08-05-2004, 01:07 PM
im guessin i should remove my exhaust? or not

kidinthehall
08-05-2004, 07:07 PM
you're making this way too complicated

TheSparo
08-05-2004, 08:51 PM
no i understand everything but im just saying so i dont get all that shit in my exhaust limiting the flow...

msaskin
08-06-2004, 01:09 PM
You won't get any shit in your exhaust, turbo, manifold, etc. The carbon all burns off, creates the smoke, then disappears.

Think of it as magic. Just do it, don't do anything special, and forget about it. Enjoy the smoke show :)

~matt

Mr. Badlose
08-06-2004, 03:44 PM
uiuc240: What were the benefits to doing this that you could feel/see?

knightrider
08-06-2004, 05:38 PM
the only precaution i took when using it was i installed a old o2 sensor i have laying around, i know the seafoam says its o2 sensor safe, i just like my sensors clean :D but i wouldnt worry if you dont have one laying around, just pour the shit in, i found it helps if you stick a small flat screw driver in the throttle stop, it raises the revs a little so the motor wont stall as easy because the throttle is partly open, this prolly isnt as easy to do on a dohc or SR cuz of where the throttle is, but it works on my sohc and my ca18, hehe. just do 1/3 of the bottle in the gas tank before you fill up, 1/3 in the oil, and the last of it through the brake booster, then just wait for ppl to come out of thier houses ready to call the FD :D

kickertu
08-06-2004, 08:18 PM
any advantages to this, besides knowing you have a clean motor?

Bryants95240sx
08-06-2004, 09:45 PM
in any yall do put it in the OIL DONT DRIVE let the car just idle for about 20 mins with it in the oil then change the oil.(for the noobs)

Spdrules5
08-07-2004, 02:15 PM
Where can one buy the seafoam or run rite? (In so-cal.)

TheSparo
08-07-2004, 09:22 PM
if you have an O Rileys (sp?) thats where i got it

mrmephistopheles
08-07-2004, 10:15 PM
an alternative method to putting it in the brake booster, is have vinyl tubing with the 'arrowtip' fitting at the end. dip one end of tube in bottom of can, and jam the fitting into the brake booster tube.