PDA

View Full Version : newb ? wont start

elipsekid
07-11-2004, 11:54 PM
:newbie:
ok my firend just got an sr swap and i dont know much about these motors...
the car will just crank and not turn over
we used the volt meter, the battery was at around 12 13volts and we would crank it and it would jump down to like 4 or 5 then we tried jumpin it and it only jumped down to like 9. as far as i know everything is all hooked up is there any pointers you gurus out there can give us?
TIA
TheTicTac
07-12-2004, 01:53 AM
Check the fuel lines. Just make sure the line from the fuel filter does not go the to Fuel Pressure Regulator.
elipsekid
07-12-2004, 10:30 PM
the line from the filter to the fpr was previously fixed
is there anything else that anyone might be able to think of??
thanks again
RiceEata
07-12-2004, 11:00 PM
did you check for spark and check to see if the engine flooding?
elipsekid
07-13-2004, 03:03 PM
the car is getting plenty of spark
anything else?
nissantuner22
07-13-2004, 04:49 PM
fuel lines. if u have spark, u dont have fuel.
augimatic
07-13-2004, 05:34 PM
Okay so the fuel line goes to the fuel filter and then.....what else???
elipsekid
07-13-2004, 06:17 PM
he pulled the injectors out and they were spraying
TheTicTac
07-14-2004, 04:31 PM
the line from the filter to the fpr was previously fixed
is there anything else that anyone might be able to think of??
thanks again

There should be no line going from the filter to the FPR. If that does not work try setting base timing. Phase2 and Srswap has a how to on timing. Make sure there are no vac leaks also.
TUnity2
07-14-2004, 05:25 PM
check your MAF and ALL vacume lines.
elipsekid
07-15-2004, 02:05 PM
There should be no line going from the filter to the FPR. If that does not work try setting base timing. Phase2 and Srswap has a how to on timing. Make sure there are no vac leaks also.

he set the timing to tdc still nothing, were just gonna replace all the vac lines and see whats gonna happen from there
hopefully it will work
thanks for all the posts