PDA

View Full Version : wat ka24de parts fit sr20 swap

sicrx
02-01-2014, 02:39 AM
Sup guys I have a ka24de in my 92 s13 and I was told that some parts can be used for sr20 swap, so far I know the ac and pw steering from ka24de can be used on sr20 and clutch plus flywheel. But what bout the perfomance exhaust and motor mounts . I need to know this bcuz I bought quite a few parts for my ka24de but im in need of more piwer and sr20 sounds best.
240boi115
02-01-2014, 02:44 AM
why not just go ka-t?
fliprayzin240sx
02-01-2014, 03:40 AM
Goodluck mating a KA flywheel to an SR. Then good luck mating a KA clutch to an SR flywheel.
90S13hatch_tony
02-01-2014, 07:20 AM
X2 on the flywheel and clutch....will NOT match up
Motor mounts are the same from ka or Sr from my understanding,
Cat back should still fit the same unless somebody shifted the position of the original bolt pattern of your downpipe
Granted if all your parts are for a s13, exhaust and mounts should work
Along with tranny mount and 5 speed driveshaft, maybe a few things I forgot about
brndck
02-01-2014, 07:39 AM
Clearly you have done your research.
Go back and try again.
sicrx
02-01-2014, 01:11 PM
K good I was just making sure of all this info, so I do need an sr20 clutch kit , wat about wire harness and ka24de tranny can I use that to plug n play or do I need sr harness and tranny
brndck
02-01-2014, 05:34 PM
wat about wire harness and ka24de tranny can I use that to plug n play or do I need sr harness and tranny

this is exactly what i'm talking about. you have done ZERO research, and just expect us to spoonfeed you. these are REALLY simple questions to find answers to. :picardfp:
g14novak
02-01-2014, 05:38 PM
K good I was just making sure of all this info, so I do need an sr20 clutch kit , wat about wire harness and ka24de tranny can I use that to plug n play or do I need sr harness and tranny

You need a usdm 200sx harness and JDM sr harness to splice together. Cut right at the ecu plug on both and match up colors. Easy as pie, I promise.

You can use the KA flywheel and tranny. Only 2 bolt holes are gonna line up. Tighten them to 2x factory spec. 200ft/lbs iirc. Make sure you get a rb20 starter or it's never gonna work tho.

Good luck.